Replace Imaging Unit Or Imaging Unit Is Near End Of Life - Xerox Phaser 6300 Service Manual

Troubleshooting Procedure Table (Continued)
Step Actions and Questions
5 Check all pins on the FAN/PHD/MOT
Harness PL10.1.9 for continuity.
1. Disconnect P/J484 and P/J48.
2. Check continuity between J48 <=> P484.
6
Replace the Imaging Unit.
Does the error persist?
Replace Imaging Unit or
Imaging Unit Is Near End of Life
The Imaging Unit Life counter indicates the Imaging Unit is near or has reached its
end of life.
Applicable Status Code:
Code 196: Replace Imaging Unit
Warning: Imaging Unit Near End of Life
Initial Actions:
Print the Supplies Usage page and verify life remaining and date Imaging
Unit was installed.
Cycle printer power.
If the problem persists, follow the procedure below
Note
The "Imaging Unit is Near End of Life" is a warning. "Replace Imaging Unit" is
a hard stop.
Troubleshooting Reference Table
Applicable Parts
Imaging Unit, PL6.1.1
CRUM Connector, PL7.1.4
PHD2 Harness, PL7.1.7
FAN/PHD/MOT Harness, PL10.1.9
3-34
Wiring and Plug/Jack References
Phaser 6300/6350 Color Laser Printer Service Manual
Yes
Go to Step 6
Replace the Engine
Control Board
(page 8-104).
Print Engine Map 2 - P/J Locator (page 10-6)
Print Engine Laser Unit Wiring (page 10-23)
No
Replace the
FAN/PHD/MOT
Harness
Complete