Wrong Paper Size; Load Tray [3][4][5] With [Size][Type] - Xerox Phaser 6300 Service Manual

Wrong Paper Size; Load Tray [3][4][5] with [size][type]

Tray [3] [4] [5] paper size mismatch error.
Applicable Status Codes:
Code 178:
Wrong Paper Size; Load Tray 3 with [size] [type]
Code 179: Wrong Paper Size; Load Tray 4 with [size] [type]
Code 180:
Wrong Paper Size; Load Tray 5 with [size] [type]
Initial Actions:
Inspect the tray to ensure that it is free of obstructions, is loaded with
supported media, and the guides are adjusted correctly.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
For 550-Sheet Feeder:
Paper Size Switch, PL11.2.6
Paper Tray, PL11.4.1
SIZE Harness, PL11.2.8
For 1100-Sheet Feeder:
Paper Size Switch, PL12.2.6
Paper Tray, PL12.6.1
SIZE2 Harness, PL12.3.5
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the affected tray for damaged parts:
Paper Size Switch, PL11.2.6,
PL12.2.6
Paper Tray, PL11.4.1, PL12.6.1
Are any parts damaged?
2 Test the affected Paper Size Switch.
Run the Service Diagnostics Paper Size
Switch test. Use the table on (page 2-7).
Do the switches function correctly?
Error Messages and Codes
Wiring and Plug/Jack References
Paper Size Switch Signal Definitions table (page 2-7)
550-Sheet Feeder P/J Locator (page 10-12)
550-Sheet Feeder Tray Wiring (page 10-35)
1100-Sheet Feeder P/J Locator (page 10-10)
1100-Sheet Feeder Tray Wiring (page 10-31)
Yes
Replace damaged
parts.
Replace the
Engine Control
Board
(page 8-104).
No
Go to Step 2.
Go to Step 3.
3-63