Non-Phaser 6300/6350 Fuser - Xerox Phaser 6300 Service Manual

Troubleshooting Procedure Table (Continued)
Step Actions and Questions
5 Check all pins on the RFID2 Harness
PL7.2.16 for continuity.
1. Disconnect P/J341 and P/J3411.
2. Check continuity between
J341<=>J3411.
6 Check all pins on the RFID Harness
PL7.2.17 for continuity.
1. Disconnect P/J3411 and P/J34.
2. Check continuity between
P3411<=>J34.

Non-Phaser 6300/6350 Fuser

A CRUM-ID error indicates that a non-Phaser 6300 Fuser is installed.
Applicable Status Code:
Code 94: Fuser CRUM ID Error
Initial Actions:
Ensure that the Fuser latches are fully latched and cycle printer power.
If the problem persists, follow the procedure below
Troubleshooting Reference Table
Applicable Parts
Fuser, PL5.1.1
FSR/ADC Harness, PL5.2.28
Engine Control Board, PL9.1.16
Warning
Avoid the potential of electric shock by removing the power cord from the
wall outlet prior to performing the following procedure.
Caution
Allow adequate time for the Fuser to cool before servicing the printer.
3-50
Wiring and Plug/Jack References
Print Engine Map 2 - P/J Locator (page 10-6)
Print Engine Map 3- P/J Locator (page 10-7)
Print Engine Fuser Wiring (page 10-22)
Phaser 6300/6350 Color Laser Printer Service Manual
Yes
Go to Step 6.
Replace the Engine
Control Board
(page 8-104).
No
Replace the
RFID2 Harness.
Replace the RFID
Harness.