Troubleshooting Procedure Table (Continued)
Step Actions and Questions
12
Check Turn Clutch resistance.
Disconnect P/J825.
Is the resistance between J825-1 <=>
J825-2 less than 200Ω?
13
Check the Feed Gear.
Does the Feed Gear in the Paper Pick
Assembly turn when printing a sheet of paper?
14
Test the Feed Solenoid.
Run the Service Diagnostics Feed Solenoid
test.
Does the solenoid function correctly?
15
Check for +24 V to the Feed Solenoid.
1. Disconnect P/J824
2. Close the Interlock Switch while testing.
Is there +24 V across P824-2 <=>ground?
16
Check all pins on the OPFDR Harness
PL11.3.24 for continuity.
1. Disconnect P/J85 and P/J824.
2. Check continuity between J85 <=> P824
17
Test the Feed Solenoid resistance.
Disconnect P/J824.
Is J824-1 <=> J824-2 less than 100Ω?
18
Check all pins on the OPFPLG Harness
PL3.2.11 for continuity.
1. Disconnect P/J171 and P/J17.
2. Check continuity between P171 <=> J17.
Error Messages and Codes
Yes
Go to Step 13.
Check the Feed
Solenoid for
damage.
Check the feed
solenoid stopper
and replace if
necessary.
Go to Step 17.
Go to Step 17.
Go to Step 17.
Replace the
Engine Control
Board
(page 8-104).
No
Replace the Turn
Clutch (Part of
the Paper Pick
Assembly)
(page 8-122).
Go to Step 14.
Go to Step 15.
Go to Step 16.
Replace the
OPFDR
Harness.
Replace the
Feed Solenoid
(Part of the
Paper Pick
Assembly)
(page 8-122).
Replace the
OPFPLG
Harness
(page 8-26).
3-25