Engine Firmware Failure
The Engine Control Board detected a firmware error.
Applicable Status Codes:
Code 70:
Fuser Temperature Control Failure
Code 71:
Long Cleaning Count Error
Code 74:
ASIC Error
Code 78:
CRUM Data Error
Code 79:
This is a generic Engine Firmware Failure code generated when any other
Engine Firmware Failure code fails to report to the controller properly.
Troubleshooting Reference Table
Applicable Parts
Engine Control Board, PL9.1.16
Troubleshooting Procedure Table
Step Actions and Questions
1
Does the error persist after the printer
power is cycled?
Engine Firmware Failure
The Engine Control Board detected a firmware error.
Applicable Status Codes:
Code
72: NVRAM error
Troubleshooting Reference Table
Applicable Parts
Engine Control Board, Pl9.1.16
EEPROM Board, PL9.1.12
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 3- P/J Locator (page 10-7)
Yes
Replace the Engine
Control Board
(page 8-104).
Wiring and Plug/Jack References
Print Engine Map 3 - P/J Locator (page 10-7)
Print Engine Xerographics (1/2) Wiring (page 10-24)
No
Complete
3-75