Replace Maintenance Kit - Xerox Phaser 6300 Service Manual

Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Fuser part number.
Is the Fuser a genuine Xerox part.
2 Check the Fuser for damage.
Is the Fuser damaged?
3
Check Fuser installation.
Remove and reinstall the Fuser.
Does the error persist?
4 Replace the Fuser.
Does the error persist?
5 Check all pins on the FSR/ADC Harness
PL5.2.28 for continuity.
1. Disconnect P/J36 and P/J361.
2. Check continuity between J36<=>J361.

Replace Maintenance Kit

The Printer detected an error condition that indicates the parts listed below need to be
replaced. This will ensure the rated engine life of 600,000 prints is achievable.
Applicable Status Code:
Code 101:
Replace Maintenance Kit
Troubleshooting Reference Table
Applicable Parts
Long-Life Maintenance Kit, 650-4360-00
Troubleshooting Procedure Table
Step Actions and Questions
1
Follow the procedure starting on page 7-4
and replace all concerned parts.
Have all parts outlined in the procedure
been replaced?
Error Messages and Codes
Yes
Go to Step 2.
Replace the Fuser.
Go to Step 4
Go to Step 5.
Replace the Engine
Control Board
(page 8-104).
Wiring and Plug/Jack References
Yes
Go to the Hidden
Service menu on
the Control Panel
and Reset the
Maintenance Kit
Life count.
No
Replace the Fuser
(page 8-5).
Go to Step 3.
Complete
Complete
Replace the FSR/
ADC Harness.
No
Replace all
concerned parts.
3-51