Printer Status Codes; Additional Information - Xerox Phaser 6300 Service Manual

Printer Status Codes

Printer status codes that appear in the Service Usage Profile at line 237, on the printer
Status page, and output by the Diagnostic Fault History utility are defined in the
following table. Refer to the "Messages, Codes, and Procedures" on page 3-5 for

additional information.

Printer Status Codes
Code Description
7 Laser Failure 7. Laser power failure.
8 Laser Failure 8. Laser Start of Scan error 1.
9 Laser Failure 9. Laser Start of Scan error 2.
10 Laser Failure 10. Laser warm-up error.
11 Laser Failure 11. General Laser Unit error.
13 Density Sensor Failure 13. CTD (ADC) Sensor failure.
14 Density Sensor Failure 14. CTD (ADC) Sensor Toner Density Control signal is over limit.
15 Density Sensor Failure 15. CTD (ADC) Sensor Toner Density Control signal is at limit.
16 Density Sensor Failure 16. General CTD (ADC) Sensor error.
40 Fuser Failure 40. Fuser exceeding temperature range.
41 Fuser Failure 41. Fuser below temperature range.
42 Fuser Failure 42. Fuser Temperature Sensor error.
43 Fuser Failure 43. Fuser did not reach warm-up temperature in time.
44 Fuser Failure 44. Fuser heater failure.
45 Fuser Failure 45. Fuser heater regulation failure.
47 Fuser Failure 47. General Fuser error.
50 Fuser Fan Failure. Fuser Fan rotation signal error.
51 Rear Fan Failure. Rear Fan rotation signal error.
52 Fan Failure. General Fan error.
70 Engine Firmware Failure 70. Fuser temperature firmware error.
71 Engine Firmware Failure 71. Cleaning count firmware error.
72 Engine Firmware Failure 72. NVRAM failure.
73 Engine Firmware Failure 73. NVRAM Checksum error.
74 Engine Firmware Failure 74. ASIC failure.
76 Fuser Firmware Failure. Fuser NVRAM failure.
77 Image Density Error. Density firmware failure.
A-4 Phaser 6300/6350 Color Laser Printer Service Manual