Misfeed At Tray 2: Jam T2; Initial Actions - Xerox Phaser 6300 Service Manual

Misfeed at Tray 2: Jam T2

Paper fed from Tray 2 did not reach the Registration Sensor on time.
Applicable Status Code:
Code 156:
Misfeed at Tray 2

Initial Actions:

Try picking paper from a different tray.
Ensure that Tray 2 is installed properly and the paper guides are set correctly.
Remove, fan, and reload supported media in Tray 2.
Remove any obstructions or debris in the paper path and cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Feed Rollers, PL3.3.18
Interlock Switch, PL9.1.11
Registration Sensor, PL4.1.3
Registration Roller PL4.2.1
Main Drive Assembly, PL8.1.2
Tray 2 Paper Pick Assembly, PL3.3.1
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the following for evidence of fault or
damage:
Feed Rollers, PL3.3.18
Paper Pick Assembly, PL3.3.1
Tray 2, PL2.1.1
Registration Sensor, PL4.1.3
Main Drive Assembly, PL8.1.2
2 Test the Registration Sensor.
Run the Service Diagnostics Registration
Sensor test.
Does the sensor function correctly?
3
Check the Registration Sensor connection.
Is the Registration Sensor connected to the
harness?
3-20
Wiring and Plug/Jack References
Print Engine Map 1 P/J Locator (page 10-5)
Print Engine Map 4 Tray 2 P/J Locator (page 10-8)
Print Engine Tray 2 Wiring (page 10-18)
Print Engine Drive Wiring Diagram (page 10-19)
Print Engine Paper Feed Wiring (page 10-26)
Phaser 6300/6350 Color Laser Printer Service Manual
Yes
Replace any
damaged or
excessively worn
parts.
Go to Step 6.
Go to Step 4.
No
Go to Step 2.
Go to Step 3.
Connect the
sensor.