Crum Reader (Pl7.2.12) - Xerox Phaser 6300 Service Manual

CRUM Reader (PL7.2.12)

1.
Remove the Top Main Cover (page 8-8).
Note
Control Toner spillage by replacing the cartridges after removing the cover.
2.
Remove the Right Side Cover (page 8-12).
3.
Remove the Left Side Cover (page 8-13).
4. Remove the Rear Cover (page 8-16).
5. Remove the 2 wires (red) from the harness guides on the CRUM Reader.
6. Remove the screw (metal, 6 mm) and the screw (self-tapping, plastic 10 mm) that
secure each end of the CRUM Reader to the frame.
7. Remove the 4 screws (self-tapping, plastic 10 mm) that secure the Toner
Cartridge Holders to the CRUM Reader.
8.
Release the boss on each Toner Cartridge Holder from the CRUM Reader.
Service Parts Disassembly
HVPS
s6300-367
8-83