Misfeed At Tray 2: Jam T2 - Xerox Phaser 6250 Service Manual

Misfeed at Tray 2: Jam T2

Try picking paper from a different tray.
Ensure that Tray 2 is free from defects and installed properly.
Remove, fan, and reload media in Tray 2.
Remove any obstructions or debris in the paper path.
Ensure that the media in Tray 2 is a supported type and size.
Ensure that the tray guides are set correctly.
Cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Paper Pick Roller Kit, PL 3.3.3
Paper Feed Roller Kit, PL 3.3.23
Paper Pick Assembly, PL 3.3.1
Chute Assembly Registration, PL 9.1.6
Troubleshooting Procedure Table
Steps Actions and Questions
1 Check the following parts for fault or
damage:
Check for worn or damaged rollers and
gears on the Paper Pick Assembly and
the Feed Roller on Tray 1.
Check Tray 1 for damage.
Registration Sensor PL 9.1.8
Main Drive Assembly PL 11.1.14
2 Use service diagnostics to test the
Registration Sensor.
Does the sensor function normally?
3 Check that the connection between the
Harness and the Registration Sensor is
properly connected and seated.
4
Check the Registration Clutch Harness
for continuity.
See "Paper Feed" on page 10-25.
Error Messages and Codes
Wiring and Plug/Jack Map References
"Paper Tray 1" on page 10-17
"Paper Feed" on page 10-25
"Drive Section" on page 10-18
"Main Wiring Diagram" on page 10-15
Yes
Replace any
damaged or
excessively worn
parts.
Go to Step 6.
Go to Step 4.
Go to Step 5.
No
Go to Step 2.
Go to Step 3.
Connect or
replace the faulty
part.
Replace the
Registration
Chute Assembly,
page 8-71.
3-33