Install Or Reseat Fuser - Xerox Phaser 6300 Service Manual

Troubleshooting Procedure Table (Continued)
Step Actions and Questions
2 Test the Toner Full Sensor.
Run the Service Diagnostics Transfer
Roller Toner Full Sensor test.
Does the sensor function correctly?
3 Check the Toner Full Sensor signal.
1. Remove the Transfer Roller Assembly.
2. Disconnect P/J142.
Does the voltage between J142-2 <=>
J142-3 = 0 V?
4 Check all pins on the TNRFULL/FSR
Harness PL5.2.30 for continuity.
1. Disconnect P/J52 and P/J142.
2. Check continuity between J52 <=> J142.
5 Replace the Transfer Roller.
Does the error persist?

Install or Reseat Fuser

The printer does not detect the presence of the Fuser.
Applicable Status Code:
Code 214: Install or Reseat Fuser
Initial Actions:
Ensure that the Fuser latches are fully latched and cycle printer power.
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL5.1.1
FSR/ADC Harness PL5.2.28
Warning
To avoid the potential of electric shock, ensure the power to the printer is off
and the power cord is disconnected from the wall outlet prior to performing
Step 2 of the following troubleshooting procedure.
Caution
Allow adequate time for the Fuser to cool before servicing the printer.
3-38
Wiring and Plug/Jack References
Print Engine Map 2 - P/J Locator (page 10-6)
Print Engine Wiring Fuser (page 10-22)
Phaser 6300/6350 Color Laser Printer Service Manual
Yes
Go to Step 5
Go to Step 5.
Replace Sensor
Toner Full.
Replace the Engine
Control Board
(page 8-104).
No
Go to Step 3.
Go to Step 4.
Replace Toner Full/
FSR Harness.
Complete