Seawater Strainer - Mercury MerCruiser D2.8L D-Tronic Service Manual

Marine engines in-line diesel
Hide thumbs Also See for MerCruiser D2.8L D-Tronic:
Table of Contents

Advertisement

SERVICE MANUAL NUMBER 22

Seawater Strainer

1. Visually inspect seawater strainer through glass top.
When cleaning seawater strainer, close seacock, if equipped. If boat is not equipped
with a seacock, remove and plug seawater inlet hose to prevent a siphoning action
that may occur, allowing seawater to flow from the drain holes or removed hoses.
Do NOT overtighten cover screws or cover will warp and leak.
2. With engine off, close seacock (if equipped) or remove and plug seawater inlet hose if
no seacock exists.
3. Remove screws, washers, and cover.
4. Remove strainer, drain plug and washer.
5. Clean all debris from strainer housing; flush both strainer and housing with clean water.
6. Check gasket and replace when necessary (if it leaks).
7. Reinstall strainer, drain plug and washer.
8. Reattach cover with screws and washers.
9. After starting engine, check for leaks and/or air in system, which would indicate an
external leak.
90-860074--1 FEBRUARY 2002
a -
Screws and Washers
b -
Cover, with glass
c -
Strainer
d -
Housing
e -
Drain Plug and Sealing Washer Gasket
CAUTION
CAUTION
a
b
f
c
d
MAINTENANCE
e
78157
Page 1B-53

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MerCruiser D2.8L D-Tronic and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Mercruiser d4.2l d-tronic

Table of Contents

Save PDF