INBOARD (MIE) MODELS
3. Ensure that coupling centerlines align, by butting propeller shaft coupler against
transmission output flange. Shoulder on propeller shaft coupler should engage recess
on transmission output flange face with no resistance.
NOTE: Some propeller shaft couplers may not have a shoulder on mating face. On these
installations, use a straight edge to check centerline alignment.
Page 2B-12
INCORRECT
INCORRECT
a-Feeler Gauge
b-Transmission Coupling
c-Propeller Shaft
d-Straight Edge
SERVICE MANUAL NUMBER 22
CORRECT
a
b
c
d
90-860074--1 FEBRUARY 2002
72597
72598