Mercury MerCruiser D2.8L D-Tronic Service Manual page 641

SERVICE MANUAL NUMBER 22
Display Terminology (Continued)
Related to
Scan Tool
P1615
P1615
P1615
P1615
P1615
P1615
P1625
P1625
P1635
P1660
P1660
P1680
P1680
P1680
P1680
P1680
90-860074--1 FEBRUARY 2002
Displayed Extended Information
As Shown On Scan Tool
Code
RECOVERY HAS OCCURRED
PREPARE ACTUATOR FOR GATE
ARRAY FUEL QUANTITY STOP
REDUNDANT OVERRUN
MONITORING
GATE ARRAY FUEL QUANTITY
STOP
GATE ARRAY MONITORING
GATE ARRAY REPROGRAMMING
SHUTS OFF TOO EARLY
SHUTS OFF TOO LATE
GENERAL PLAUSIBILITY ERROR
POWER STAGE DEFECT
PLAUSIBILITY IN AFTER-RUN
CHECKSUM ERROR IN CC212
VALUE
CHECKSUM ERROR
COMMUNICATION ERROR
WRONG EPROM NUMBER
WRONG CODE NUMBER
EDI DIAGNOSIS
Explanation / Possible
Cause
Clear the code(s) and start the
engine. If the same fault
occurs at each start, replace
the ECM.
The main relay shut off
BEFORE the ECM gave the
shut off command. Replace
the ECM.
The main relay shut off
AFTER the ECM gave the
shut off command. Replace
the ECM.
Not recognized by Marine
ECM application.
An error was saved at ignition
OFF when the shut off valve OFF when the shut off valve
circuit was tested. Check the
circuit and valve.
A problem in the ECM
converting fuel quantity sensor
signal. An internal ECM
problem. Replace the ECM.
An internal ECM problem.
Replace the ECM.
An internal ECM problem.
Replace the ECM.
An internal ECM problem.
Replace the ECM.
An internal ECM problem.
Replace the ECM.
Page 5E-73