SERVICE MANUAL NUMBER 22
13. If the alignment tool does not fit, remove it and carefully adjust engine mounts as
necessary:
a. To Adjust Engine Up or Down: Loosen locknut on mounts. Turn adjusting nuts as
IMPORTANT: Large diameter of mount trunion MUST NOT extend over 19 mm (3/4 in.)
from edge of mount bracket to centerline of mount stud.
b. To Move Engine Left or Right: Loosen trunion clamping bolts on both front mounts
NOTE: A small amount of side-to-side adjustment can be obtained from the slots on the
engine mount pads.
Typical
90-860074--1 FEBRUARY 2002
necessary. Retighten locknuts.
and move engine as necessary. Do NOT over-extend mount trunion. Retighten
locking nuts.
a -
Locknut
b -
Bracket
c -
Mount Adjustment Nut
d -
Lag Bolts
e -
Clamp
f -
Clamp Spread-Screw
g -
Nuts
g
a
b
d
STERNDRIVE (MCM) MODELS
f
e
c
23161
Page 2A-11