SERVICE MANUAL NUMBER 22
8. Remove adjustment tool.
9. Shift remote control lever into full forward position. Place end of adjustment tool in barrel
retainer.
Rh Rotation - All Bravo One, Two, And Three Models: Rear slot in tool should fit over shift
lever stud.
Lh Rotation - All Bravo One And Two Models: Forward slot in tool should fit over shift
lever stud.
If slot does not fit over stud, loosen shift lever stud and slide stud either direction, until slot
in tool fits over stud. When adjustment is correct, retighten stud.
RH Rotation - All Bravo One, Two, Three
LH Rotation - All Bravo One And Two
10. Remove adjustment tool.
11. Lubricate shift cable pivot points with 30W engine oil.
90-860074--1 FEBRUARY 2002
a -
Adjustment Tool
b -
Barrel Retainer
c -
Shift Lever Stud
d -
Shift Lever Adjustment Slot
a
c
b
a
b
STERNDRIVE (MCM) MODELS
d
c
d
23242
23242
Page 2A-27