Installation; Engine Installation And Initial Alignment - Mercury MerCruiser D2.8L D-Tronic Service Manual

SERVICE MANUAL NUMBER 22

Installation

Engine Installation and Initial Alignment

1. Engine mount or mount adjustment WAS NOT DISTURBED during engine
service: Proceed to following Step 3.
2. Engine mount or mount adjustment WAS DISTURBED during engine service:
IMPORTANT: Engine mounts must be adjusted, as explained in the following, to
center mount adjustment and establish a uniform height on all mounts.
Ensure that:
a. All mounts are in the center of their up-and-down adjustment.
b. Large diameter of mount trunnion extended no more than 19 mm (3/4 in.).
c. Each mount base is downward. Tighten clamping screws and nuts slightly to prevent
90-860074--1 FEBRUARY 2002
moving in or out. Mounts must be free to pivot when installing engine.
b
a
Typical Front Mount
a-Trunnion Clamping Bolt and Nut
b-Mount Trunnion Extension
b
23161
INBOARD (MIE) MODELS
b
b
a
Typical Rear Mount
27035
Page 2B-7