ENGINE MECHANICAL
5. Align camshaft gear marks with idler gear marks as shown. Torque camshaft flange
mounting screws to 27.5 Nm (20 lb-ft).
6. Complete the engine assembly.
Camshaft Bearings
Inspection
With camshaft removed:
1. Visually inspect bearings. Renew if worn or damaged.
2. Measure inner diameter of bearings. Refer to specifications. Renew bearings if not
within specifications.
Removal
NOTE: Camshaft bearings can only be removed and installed with crankshaft removed.
1. Using special tool 91-801333508 with appropriate hardware, remove camshaft
bearings into receiver end of tool (not shown in this view).
Page 3A-100
b
a -
Camshaft Gear
b -
Idler Gear
c -
Marks Aligned Properly
d -
Mounting Screws With Lockwashers
a
a -
Cylinder Block
b -
Special Tool
c -
Camshaft Bearing Bore
c
d
c
b
SERVICE MANUAL NUMBER 22
a
90-860074--1 FEBRUARY 2002
70289
70438