SERVICE MANUAL NUMBER 22
9. Connect coolant recovery bottle hose to heat exchanger and secure with clamp.
Throttle Cable Installation and Adjustment
Refer to SECTION 2A.
Shift Cable Installation And Adjustment
Refer to SECTION 8A.
Battery Cables
1. Connect battery cables to engine:
a. Make sure that grounding stud and starter solenoid terminal are free of paint and any
b. After battery cables are connected, apply a thin coat of liquid neoprene to the
c. Slide rubber boot over the positive (+) terminal after liquid neoprene dries.
2. Connect battery cables to battery by FIRST connecting positive (+) battery cable
(usually red) to positive (+) battery terminal. Tighten clamp securely. Then, connect
negative (–) battery cable (usually black) to negative (–) battery terminal. Tighten clamp
securely.
NOTE: Spray terminals with a battery connection sealant to help retard corrosion.
90-860074--1 FEBRUARY 2002
a-Hose
b-Clamp
other material that could cause a poor electrical connection.
terminals.
b
a
INBOARD (MIE) MODELS
70548
Page 2B-21