Filter Knob Position Adjustment - Sony HDW-750 Maintenance Manual

1-20. Filter Knob Position Adjustment

1-20. Filter Knob Position Adjustment
n
Procedure of the filter knob position adjustment is different
depending on the type of the incorporated filter.
1. Move the mount lever in the direction of the arrow and
remove the mount cap.
n
Be very careful not to touch the filter surface when the
mount cap is removed.
Mount cap
1-56
When a dual filter is incorporated :
2. Rotate the knob shaft (thick) until the filter of the
thinnest color is visible from the front.
3. Align the file (CC) knob number "B" with the mark on
the inside panel assembly and attach it with the use of
the two stop screws (A).
4. Rotate the knob shaft (thin) until the filter of the
thinnest color is visible from the front.
5. Align the file (ND) knob number "1" with the mark on
the inside panel assembly and attach it with the use of
the two stop screws (B).
Stop screws (B)
WP2 x 3
Filter (ND)
knob
Mount
Stop screws (B)
lever
WP2 x 3
Filter (ND) knob
When a single filter is incorporated :
2. Rotate the knob shaft until the filter of the thinnest
color is visible from the front.
3. Align the filter knob number "1" with the mark on the
inside panel assembly and attach it with the use of the
two stop screw.
Stop screw
WP3 x 3
Filter knob
n
Standard tightening torque :
WP2 x 3 : 20 to 25 x 10
WP3 x 3 : 53 x 10
Knob shaft (thin)
Stop screw (A)
WP2 x 3
1
B
Stop screw
(A) WP2 x 3
1
Filter (CC) knob
Inside panel assembly
Knob shaft
1
Mark
_2
N.m (2 to 2.5 kgf.cm)
_2
N.m (5.3 kfg.cm)
Knob shaft (thick)
Mark
Inside panel
assembly
HDW-750/750CE V1