Tension Regulator Position Adjustment - Sony CCD-M8U Service Manual

Tension Regulator Position Adjustment

2-3- 3 1 .
Removal
1 .
1 ) B y referring t o 2- 1 - 1 and 2-1 -2. remove cassette arm
assembly and LS cassette compartment assembly.
2. Adjustment
Turn into
tape. (See Fig. 2- 1 -4)
I n tape running state. confirm whether the arrow marked Q
2)
point is positioned at the point (arrow mark © ) I /3
within the thickness of LS guide
Fig. 2-46)
3)
When it is not at the specified position. remove the cassette
and perform the adjustments described in after step 4).
4) Loosen screw 8 .
5) I f TG-1 arm assembly
specified position. shift the tension regulating band plate
0
slightly in the direction of arrow (i . If it is in the outer
side. shift it slightly in the direction of arrow @) and secure
8 .
it with screw ( See Fig. 2-47)
Notes:
I
Use a cassette tape which has been forwarded to about
1
the middle section.
When performing step 2 ) , the cassette tape should be
2 )
removed in advance.
Installation
3.
By referring to 2- 1 - 1 and 2-1 -2. install cassette arm
assembly and LS cassette compartment assembly.
f)
or not.
O
is within the inner side than the
( See
•
LS guide
8 Screw
- -
6 3
b = 1/3a
Fig. 2-46
3
0
Tension regulating band plate
Fig. 2-47
Tape