Mechanical Deck Assembly Removal/Installation - Sony HDW-750 Maintenance Manual

7-35. Mechanical Deck Assembly Removal/Installation

7-35. Mechanical Deck Assembly Removal/Installation
Overview
Removal/Installation
Removing the mechanical deck assembly
Installing the mechanical deck assembly
Adjustment after installation
Tape Run Adjustment
Preparations
1. Turn off the main power.
2. Remove the front lid and outside panel assembly. (Refer to Section 1-4.)
3. Open the inside panel assembly. (Refer to Section 1-5.)
4. Removing the plug-in boards (Refer to Section 1-7.)
5. Removing the SS-92 board (Refer to Section 6-21.)
n
Removal and installation of mechanical deck assembly can be performed in the state
that the cassette compartment is being installed in the unit.
Tools
. Hexagon bit (across 1.5 m) :
. Torque screwdriver (for 3 kg) : J-6325-400-A
Removal
1. Removing the mechanical deck
assembly
(1) Remove the flexible card wire from the
connector (CN4) on the MDR-14 board and
the connector (CN101) on the MB-898 board.
n
Life of flexible card wire will be significantly
shortened if it is folded. Be very careful not
to fold the flexible card wire.
7-122
J-6326-120-A
MDR-14 board
CN4
Flexible card wires
CN101
MB-898 board
HDW-750/750CE V1