Shutter, Auto W/B Bal Switch And Audio Volume; Controls Replacement - Sony HDW-750 Maintenance Manual

6-4. Shutter, AUTO W/B BAL Switch and AUDIO Volume Controls Replacement
6-4. Shutter, AUTO W/B BAL
Switch and AUDIO Volume

Controls Replacement

1. Remove the front assembly.
(Refer to Section 6-1.)
2. Loosen the two screws fixing the harness
(lens) and remove the three screws from the
front SW sub assembly.
3. While removing the projection of the SW-
1031 board from the front assembly, remove
the front SW assembly.
4. Remove the two screws and remove the SW-
1031 board from the front SW sub assembly.
n
Depending on the time of production at the
factory, the VTR START switch is equipped
with the cushion in some production units. In
such a case, be careful not to lose the
cushion.
5. Remove the soldering. Remove the shutter
switch, AUTO W/B BAL switch and AUDIO
volume controls.
6-8
Front assembly
Precision screws
P2.6 x 5
Harness (lens)
Front SW
assembly
Projection of
Precision screw
the SW-1031 board
P2.6 x 5
Shield plate (FR) Front SW sub assembly
AUTO W/B BAL switch
Audio volume control
Projection
VR (audio) knob
Cushion
Shutter switch
VTR start switch
P2.6 x 8
SW-1031 board
HDW-750/750CE V1