Sony HDW-750 Maintenance Manual page 258

6-16. Battery Connector Assembly (DC-111 Board) Replacement
6-16. Battery Connector Assembly
(DC-111 Board) Replacement
1. Open the inside panel assembly.
(Refer to Section 1-5.)
2. Remove the plug-in boards.
(Refer to Section 1-7.)
3. Remove the connector box assembly.
(Refer to Section 1-6.)
4. Disconnect the harness from the connector
(CN115) on the MB-898 board.
5. Remove the four precision screws. While
removing the shield finger (BATT) and
battery connector assembly, pull the two
harnesses out of the hole.
n
Be careful not to damage the harness as it is
caught by the frame.
6. Install the new battery connector assembly by
reversing the steps of removal.
Standard tightening torque :
40 x 10 _2
N.m (4 kgf.cm)
6-28
Shield finger (BATT)
Precision
Precision
screw
screws
P2.6 x 5
P2.6 x 5
CN115
MB-898 board
Hole
Battery connector
assembly
HDW-750/750CE V1