Ms Lid Assembly Replacement - Sony HDW-750 Maintenance Manual

6-12. MS Lid Assembly Replacement

6-12. MS Lid Assembly Replacement
1. Open the SW door of the inside panel
assembly in the direction of the arrow.
Remove the two set screws and remove the
two VR knobs (2).
n
Depending on the time of production at the
factory, the VR knob (2) is changed to what
has no stop screw.
2. Open the inside panel assembly.
(Refer to Section 1-5.)
3. Remove the screw and the FR flexible cable
retainer.
n
Depending on the time of production at the
factory, some production units do not use the
FR flexible cable retainer.
4. Remove the three precision screws and
remove the shield plate.
5. Disconnect the flexible card wires from the
connectors (CN105 to CN107) on the MB-
898 board.
n
Life of flexible card wire will be significantly
shortened if it is folded. Be very careful not
to fold the flexible card wire.
6. Disengage the hinge from the two hooks and
remove the inside panel assembly from the
unit.
6-22
Precision
screws
P2 x 4
CN106
CN105
MB-898
board
Flexible card wires
Hinge
Hook
Stop screws
WP2 x 3
VR knob (2)
SW door
FR flexible cable retainer
Precision
screws
P2 x 4
Shield plate
CN107
Hook
Hinge
Inside panel
assembly
HDW-750/750CE V1