Protection operation when SLACK is detected
When SLACK is detected, the tape run system stops automatically.
Tape eject operation when SLACK is detected
Even when SLACK is detected, the EJECT command can be accepted but the tape is unthreaded inter-
ruptedly as described below.
1) When the EJECT key is pressed, the tape is unthreaded for a certain period of time and after that tape
stops.
2) When the EJECT key is kept pressed, unthreading and pausing are repeated until the tape is com-
pletely ejected.
The moment the EJECT key is released, the tape remains in the stop state.
When the Emergency EJECT is activated
When the Emergency EJECT is activated, there are cases that the tape is rewound.
If you continue recording from the point of Emergency EJECT, the previously recorded information will
be possibly overwritten. To avoid this trouble, be sure to check the tape position whenever you have
activated Emergency EJECT.
HDW-750/750CE V1
3-1. When Does the Error Code Appear?
3-3