S-Tension Regulator Band Assembly Replacement - Sony HDW-750 Maintenance Manual

7-8. S-tension Regulator Band Assembly Replacement

7-8. S-Tension Regulator Band Assembly Replacement
Overview
Replacement
Removing the S-tension regulator band assembly
Cleaning S reel table
Installing the S-tension regulator band assembly
Adjustments after replacement
S tension regulator operating position adjustment
FWD Back Tension adjustment
Tape run adjustment
Capstan add-on recording adjustment
Notes
If felt surface of the S-tension regulator band assembly becomes hardened, or worn
out, replace the S-tension regulator band assembly as an entire assembly.
Preparations
1. Turn off the main power.
2. Remove the front lid and outside panel assembly. (Refer to Section 1-4.)
3. Remove the cassette compartment. (Refer to Section 1-9.)
4. Check that the unit is in the unthreading-end state.
n
The stop washer is used to fix the tension regulator band assembly.
Prepare a new stop washer (3-559-408-11) when replacing the tension regulator
band assembly.
Tools
. Stop washer fastening tool : J-6323-530-A
. Cleaning cloth :
. Cleaning fluid :
7-44
3-184-527-01
9-919-573-01
HDW-750/750CE V1