6-2. Filter Disk Unit Replacement
n
Replace the filter disk unit in the place such as clean room that is free from dust.
Removal
1. Remove the outside panel assembly.
(Refer to Section 1-4.)
2. Open the inside panel assembly.
(Refer to Section 1-5.)
3. Remove the CCD unit. (Refer to 6-1-1.)
4. Remove the two screws and disconnect the
harness from the connector (CN3) on the DR-
433 board (DR-477 board) and take the filter
disk unit out gently.
Installation
1. Install the new filter disk unit by reversing
step 4 of removal.
n
When installing the filter disk unit, be careful
not touch the surface of the filter disk unit
with hand.
2. Install the CCD unit. (Refer to Section 6-1-1.)
Adjustment after Replacement
Adjustment after Replace of the Filter Disk Unit
(Refer to Section 9-28.)
HDW-750/750CE V1
Filter disk unit
K3 x 6
CCD unit
6-2. Filter Disk Unit Replacement
CN3
DR-433 board
(DR-477 board)
6-5