Sony HDW-750 Maintenance Manual page 188

4-9. SERVICE Menu
DCP ADJUST Display (Adjusting the DCP-28 board)
O
? 05 DCP ADJUST
VF Y DC LEVEL
VCO CONT
RGB OUT R LEVEL :
RGB OUT B LEVEL :
DETAIL BALANCE
Item
VF Y DC LEVEL
VCO CONT
RGB OUT R LEVEL
RGB OUT B LEVEL
DETAIL BALANCE
RP DC OFFSET Display (Adjusting the DC value of the RP-123/RP-127 board)
O
? 06 RP DC OFFSET
R DC OFFSET 0
R DC OFFSET 180 :
G DC OFFSET 0
G DC OFFSET 180 :
B DC OFFSET 0
B DC OFFSET 180 :
DC ADJ MODE
OUTPUT SELECT
Item
R DC OFFSET 0
R DC OFFSET 180
G DC OFFSET 0
G DC OFFSET 180
B DC OFFSET 0
B DC OFFSET 180
*1
DC ADJ MODE
OUTPUT SELECT
*1 : This item is displayed only when the RP-127 board is used.
*2 :RGB can be selected only when the Camcorder is used in the service mode.
4-66
: 0
: 0
0
0
: 0
Setting Function
(_99 to 99) Adjusts the black level of the signal that is output to VF.
(_99 to 99) Adjusts the oscillating frequency.
(_99 to 99) Adjusts the R-signal level when the OUTPUT SELECT is set to RGB.
(_99 to 99) Adjusts the B-signal level when the OUTPUT SELECT is set to RGB.
Reference : When the OUTPUT SELECT is set to RGB upon
(_8 to 8) Adjusts the right-side and the left-side balance on screen of
the detail signal.
: 0
0
: 0
0
: 0
0
: OFF
: Y
Setting Function
(_99 to 99) R DC 0 phase adjustment
(_99 to 99) R DC p phase adjustment
(_99 to 99) G DC 0 phase adjustment
(_99 to 99) G DC p phase adjustment
(_99 to 99) B DC 0 phase adjustment
(_99 to 99) B DC p phase adjustment
OFF/ON Turns ON/OFF of the DC ADJ MODE.How to adjust the DC ADJ,
refer to "9-6. Black Offset Adjustment" of this manual.
Y/R/G/B/RGB *2 Selects the video signal that is output from the TEST OUT and
the VBS/SDI OUT terminal. (The Y-signal becomes the VBS
signal when the REAR BNC OUT SEL of the OUTPUT SEL
display of the OPERATION menu selects the VBS position and
when the TEST OUT SELECT chooses the SD position.) The
output signal returns to the Y-signal without fail at power-on.
completion of the Y/Pb/Pr signal level adjustment, the
offset values are adjusted by the RGB OUT R/B
LEVEL. Because the digital output code of Pr/Pb is
larger than the digital output code of R/G/B, a slight
level difference is generated between the above two
signals when the same output signal amplitude of 700
mV is desired at the analog OUT connector.
HDW-750/750CE V1