Vf Connector Replacement - Sony HDW-750 Maintenance Manual

12. Install the new MS lid assembly by reversing
the steps of removal.
Note on installation
When the FR flexible cable retainer is available,
secure the flexible card wire with it as shown.

6-13. VF Connector Replacement

1. Remove the outside panel assembly.
(Refer to Section 1-4.)
2. Open the inside panel assembly.
(Refer to Section 1-5.)
3. Remove the front assembly.
(Refer to Section 6-1-1.)
4. Remove the handle assembly.
(Refer to Section 6-23.)
5. Remove the two screws (P2 x 4) and remove
the bracket (DCP).
6. Disconnect the harness from the coating lead
pin.
7. Disconnect the harness from the connector
(CN4) on the DCP-28 board.
8. Remove the two precision screws (P2.6 x 5)
and remove the VF connector.
9. Open the claws of the sleeve ferrite clamp by
pressing them, that are attached to the
harness, and remove the sleeve ferrite clamp.
n
Depending on the time of production at the
factory, there are sets that do not use the
sleeve ferrite clamp.
10. Install the new VF connector by reversing the
steps of removal.When the unit under
servicing uses the sleeve ferrite clamp,
replace it.
HDW-750/750CE V1
Inside panel assembly
Precision
screws
P2 x 4
Shield plate
Sleeve ferrite clamp
Claw
VF connector
Precision screws
P2.6 x 5
Direction when
the VF connector
is installed.
6-12. MS Lid Assembly Replacement
6-13. VF Connector Replacement
Chassis side
FP-121 board
FR flexible
cable retainer
Flexible card wires
DCP-28 board
Coating lead pin
CN4
P2 x 4
Harness
Bracket (DCP)
6-25