74
7. Cylinder Head Valve
Disassembling of Camshaft
1. Disassemble middle cover. (2-2)
2. Remove four bolts and two nuts, take off
valve cover.
3. Disassemble cam chair adjusting bolt and
spring.
4. Use the kick-start lever to slowly turn engine
until "T" mark on flywheel lines up with indicator
on crankcase. Check position of camshaft to
find if both valves are closed. The hole in the
cam gear should be away from the engine. If
this is not correct, rotate the crank one
revolution to achieve this alignment.
5. Remove four bolts and remove camshaft
caps.
CAMSHAFT
CHAIN GEAR
4
HOLE IN CAM GEAR
AWAY FROM ENGINE
"T" MARK
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
5
7-4
2
CYLINDER
HEAD COVER
3
CHAPTER 7: CYLINDER HEAD VALVE
3