Panterra Fusion Service Manual page 15

12
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
1. General Information
Tool Requirements
For general maintenance and repair of the
scooter, a complete basic set of metric sized
tools is required. This should include; Open-end
wrenches, sockets and ratchet, hex keys, straight
and Philips screw drivers, standard pliers,
needle-nosed pliers, wire cutters, wire strippers,
scraper, pin punch, hammer and soft faced mallet.
For a more extensive tear down and rebuild of the
scooter, there are a variety of special tools that
will be required. These include the following:
•Valve spring compressor
•Valve guide reamer
•Feeler gage set
•Slide hammer bearing and seal remover
•Bearing press
•Torque wrench
•Ring compressor
•Clutch spring compressor
•Fly wheel puller
•Electronic multi meter
1-12
CHAPTER 1: INTRODUCTION