Engine Oil/Filter Screen; Oil Volume; Oil Changed - Panterra Fusion Service Manual

NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
4. Lubricating System
Engine Oil/Filter Screen

Oil Volume

1. Check oil with scooter parked on level
ground on center stand.
Put scooter on the plain place when
oil volume is checked.
Run engine for two or three minutes
and then turn it off. After two to three
minutes, check the oil level.
2. Check the oil level when the oil dipstick is
unscrewed and out.
3. Add oil to upper limit level on the dipstick.

Oil Changed

It is easier to drain oil when motor is
warm.
1. Remove drain bolt to completely drain oil.
2. Disassemble the oil filter screen cover
and take off the oil filter screen. Use
high-pressure air to clean the filter screen.
Wash with solvent and dry before reinstalling.
3. Check o-ring for damage. Replace if
necessary.
4. Assemble engine oil filter screen and filter
screen cover.
•Torsion value: 1.4kg-m
1300 ft lbs
5. Add assigned oil to determined volume.
•Engine oil capacity: 0.8L
•320ES
6. Check for oil leaks.
7. Run engine for 1-2 minutes at idle speed.
8. Turn engine off and check oil level. Add
oil if needed.
CHAPTER 4: LUBRICATING SYSTEM
2
DIPSTICK
DRAIN BOLT
0IL FILTER SCREEN
0-RING
3
4-3
47
1