The Clutch/Transmission Pulley; Disassembling The Clutch - Panterra Fusion Service Manual

NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
9. Driving Belt Device & The Starting Lever

The Clutch/Transmission Pulley

Removing the Clutch/Transmission
Pulley
1. Remove the driving pulley. Then
use a spanner wrench to hold the
clutch housing to screw out the 10mm
(.39 in.) nut.
2. Remove the clutch housing.
Remove the clutch/transmission pulley.
Remove the driving belt from the
clutch/transmission pulley.
DRIVING BELT
CLUTCH
HOUSING
2
Disassembling the
Clutch/Transmission Pulley
5. Use a spring compressor for the
clutch spring to press down the
transmission pulley spring to remove
the special nut (28mm, 1.102 in.).
6. Remove the clutch spring.
7. Remove the sealing cover of the
shaft collar.
CHAPTER 9: DRIVING BELT DEVICE & THE STARTING LEVER
CLUTCH HOUSING
SPANNER
WRENCH
10mm
FIX NUT
1
CLUTCH TRANSMISSION PULLEY
SEAL COVERING
OF SHAFT COLLAR
9-10
7
105