Panterra Fusion Service Manual page 166

NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
15. Ignition System
CDI Inspection
1. Remove the three screws from the
battery case cover.
2. Disconnect the CDI module from the wire
harness.
3. Test resistance of the terminals with a
multi-meter.
Attention:
Since there is semiconductor in
return circuit, testing results may be
significantly different if different multi-
meters are used.
If the pointer on the dial flickers and
finally stops at in testing, it should
be regarded as normal. Because the
capacitor in the CDI module is
charged while being tested, it cannot
discharge at this time.
CHAPTER 15: IGNITION SYSTEM
1
2
3
BLACK/YELLOW
BLUE/YELLOW
GREEN
BLACK/RED
BLACK/WHITE
15-4
163