Assembling Sequence - Panterra Fusion Service Manual

134
12. The Front Wheel, Front Brake,
Front Buffer and the Front Fork
5. Install the buffer spring on the guide
lever of the damper, then into the front fork
tube. Then install the buffer spring and
lock the nuts.
Attention:
When laying down the spring, keep
the coil-tight of it down.
6. Use a bench vise to secure the shock
bottom tube, and then tighten the socket
bolt.
7. Spread the thread locking compound to
the washer and the bolt, and then tighten
them up together.
Torque: 1.5-3.0kg/m 10-15ft lbs
Designated: Special damper oil
Volume: 85ml (30 ounces)
8. Attach the outer retainer and then the
dust-proof cover.

Assembling Sequence

1. Attach the front shock.
2. Install down the upper clamp bolt.
Tighten the lower and upper clamp bolts.
Attention:
Make sure that the joint of the
upper bolt hole and the groove of
the front fork tube (front damper)
are properly aligned.
3. Attach the front wheel (refer to 12-4).
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
1
2
12-11
CHAPTER 12: THE FRONT WHEEL, FRONT BRAKE,
FRONT BUFFER AND THE FRONT FORK