Panterra Fusion Service Manual page 32

NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
2. Body Cover and Exhaust System
Body Cover Removal
Front Panel Removal
1. Remove one front cover
screw from front of panel.
2. Remove two screws on both
left and right sides. Remove
front panel. Install front panel in
the reverse order.
Front Cover Removal
3. Remover rear cover, left and
right side covers and front wheel.
4. Remove two screws in front
cover (4a).
and remove two screws on each
side (left and right) (4b). Remove
front cover.
5. Install front cover in the
reverse removal order.
6. Make sure to support the
scooter while removing the front
wheel to prevent it from
falling.
Front and Rear Handlebar
Cover Removal
7. Remove two screws on front
of handlebar cover and remove
one screw in both right and left
sides of rear handlebar cover.
8. Disconnect headlight lead
and remove front handlebar
cover.
9. Disconnect speedometer
lead, left and right switches and
brake switch connector. Remove
one fix screw in rear handlebar
cover.
10. Remove the fix screw in each
side of rear handlebar cover.
Remove rear handlebar cover.
11. Remove the removal order
for installation.
CHAPTER 2: BODY COVER AND EXHAUST SYSTEM
FRONT COVER
7
FRONT
HANDLEBAR
COVER
FRONT BRAKE
CABLE
FRONT BRAKE
SWITCH LEAD
2-2
4a
SCREWS
4b
SPEEDOMETER CABLE
9
REAR BRAKE
SWITCH LEAD
REAR BRAKE CABLE
29