Fuel Sensor Removal; Fuel Sensor Installation; Fuel Sensor Testing; Fuel Gauge Inspection - Panterra Fusion Service Manual

NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
17. Meters, Switches and Lighting System

Fuel Sensor Removal

Avoid sparks and flames when working
on the fuel system.
1. Remove the middle luggage box.
2. Remove the right body panel.
3. Disconnect the fuel sensor from the wire
harness.
4. Remove the bolt of the fuel sensor.
Make sure not to damage the fuel
sensor lead.
5. Remove the fuel sensor.
Be sure that the fuel sensor float is not
beat.

Fuel Sensor Installation

6. Reverse the removal procedure for
installation.
7. Be sure to align the groove on the fuel
sensor with the mark on the fuel tank.
8. The mark on the sensor should be aligned
with that on the fuel tank.

Fuel Sensor Testing

1. Remove the fuel sensor.
2. Measure the resistance of each terminal
with the float in each position.

Fuel Gauge Inspection

With the ignition switch "ON," connect the lead.
Turn on the turn signal to be sure the
battery-return circuit is intact before performing
the inspection. Check the gauge reading by
changing the float position.
CHAPTER 17:METERS, SWITCHES AND LIGHTING SYSTEM
4
Lead Terminal Float Up
Gree-Blue/White 7+/- 2 OHM
Float Position Reading
Up
Down
17-3
Float Down
96+/- 2 OHM
F
E
175