120
11. The Crankcase and the Crankshaft
2. Check the clearance of the journal of the
big end of the connecting rod in X-Y directions.
Maximum service allowance:
Replace when it goes beyond 0.05mm
(.002 in.).
3. Measure the run-out of the crankshaft.
Maximum service allowance;
Replace when it goes beyond 0.10mm
(.004 in.).
4. Check if there is any abnormal noise and
looseness when the crankshaft bearing
revolves. Replace totally if any abnormal
noise/looseness is detected.
Assembling the Crankcase
1. Use the following tools to install the oil seal
of the crankcase:
•Bearing outer race driver
•Bearing outer race 32x35mm
(1.26 in. x 1.38 in.)
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
2
3
CRANKSHAFT
BEARING
11-5
CHAPTER 11: THE CRANKCASE AND THE CRANKSHAFT