Panterra Fusion Service Manual page 167

164
15. Ignition System
Ignition Coil Removal Steps
1. Remove the middle box.
2. Remove the spark plug cap.
3. Disconnect the wires, remove the ignition
coil jam nuts and remove the ignition coil.
Inspection
4. Check the ignition coil circuit. The spark
advance angle does not need to be adjusted.
If the spark advance is abnormal, check the
CDI, pickup coil or magneto. Replace the
ignition coil if necessary.
5. Test the primary coil resistance, the
standard value of which should be 0.1-1.0
6. Test the secondary coil resistance from
spark plug cap negative terminals. The
standard value should be 7-9k
Ω
and 3-4k (without cap).
7. Test coil using after-market spark tester.
8. Perform the following inspection in
accordance with the operating instructions in
the manual.
a. Set the ignition coil tester switch
to 12V and connect the tester to
the ignition coil.
b. Turn the switch to the ON position
to check spark frequency from the
inspection door.
In good condition: Sparking continuously
In faulty condition: Sparking abnormally.
Ω
.
Ω
(with cap)
15-5
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
CHAPTER 15: IGNITION SYSTEM