Panterra Fusion Service Manual page 171

168
16. Starter System
Starter Motor Removal
Never work on the starter
motor until main switch is
turned off and the battery
ground wire is
disconnected to ensure
that the motor cannot
turn.
1. Remove the starter motor
lead clamp.
2. Remove the two bolts and
remove the starter motor.
3. Roll up the water-proof rubber
cover to disconnect the starter
motor.
Starter Disassembly
1. Remove the two case bolts
and remove the motor housing
from the internal parts.
Starter Inspection
2. Inspect brushes and
commutator for wear, damage or
discoloration. Replace if
necessary.
3. Clean attached metal particles
from the commutator surfaces.
4. Measure the resistance
between each contact surface of
the components.
5. Make sure there is no
conduction current between each
commutator segment and the
armature shaft.
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
STARTER MOTOR
HOUSING
3a
1a
16-3
2
3b
1b
CHAPTER 16:STARTER SYSTEM