Panterra Fusion Service Manual page 174

Gasoline powered scooter
Table of Contents

Advertisement

171
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
16. Starter System
3. To inspect starter relay voltage: Stand the
scooter on is center stand, measure the voltage
between the starter relay negative terminal
(green/yellow cable) and the ground.
Turn the main switch to "on", pull the brake
levers and make sure the battery voltage is
available at the relay (12 volts). If there is no
battery voltage, inspect the brake switch
electrical conductivity and wiring.
To inspect starter relay:
1. Remove the right side body panel.
5
2. Disconnect the starter relay unit coupler
A
from the wire harness and remove it. Use ohm
meter or continuity tester to check coil.
3. Connect the meter to terminals card D.
This circuit should read closed. Use ohm meter
6D
or continuity tester C.
4. Check contactor.
B
5. Connect the meter to terminals A and B.
C
This circuit should read open with terminals C
and D disconnected and read closed with
terminals C and D applied to 12 volt supply.
2
Starter Motor Installation
1. Apply grease to the starter motor o-ring
and install the starter motor.
2. Install the two bolts.
3. Connect the starter motor terminals to the
harness.
16-6
CHAPTER 16:STARTER SYSTEM

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

FreedomRetro

Table of Contents