Assembling The Driving Pulley; Checking And Assembling; The Overrunning Clutch - Panterra Fusion Service Manual

104
9. Driving Belt Device & The Starting Lever

Assembling the Driving Pulley

1. Install the driving pulley sleeve and the
driving pulley on the crankshaft (1a). Install the
driving belt on the crankshaft (1b). Install the
driving pulley and the washer (1c).
Tighten 10mm (.39 in.) nut.
Torque: 3.8kg/m 28ft lbs
Attention:
There mustn't be any grease on the
surface of the driven belt and the driving
pulley.
The Overrunning Clutch (Starter Pinion)
Removal
2. Remove the left crankcase cover .
3. Remove the driving pulley.
4. Remove the seat of the overrunning clutch.
5. Remove the overrunning clutch.

Checking and Assembling

6. Check if the bearing part of the overrunning
clutch shaft is worn.
7. Check if the clutch runs smoothly.
8. Check the wear of the gear and the bearing
part of the shaft.
9. Coat the bearing part of the clutch shaft
with a bit of grease.
10. Assemble it in the opposite sequence of
removal.
OVERRUNNING
CLUTCH
5
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
1a
DRIVING PULLEY
SLEEVE
1b
DRIVING
BELT
1b
DRIVING
PULLEY
Overrunning Clutch
6
9-9
CHAPTER 9: DRIVING BELT DEVICE & THE STARTING LEVER
BEARING SECTION
OF SHAFT