Panterra Fusion Service Manual page 177

174
17. Meters, Switches and Lighting System
Topic
Maintenance information
Troubleshooting
Fuel Sensor Removal
Fuel Sensor Installation
Fuel Sensor Testing
Fuel Gauge Inspection
Handlebar switch
Light Switch Inspection
Starter Switch Inspection
Dimmer Switch Inspection
Turn Light Switch Inspection
Engine Stop Switch Inspection
Horn Switch
Maintenance
Operating Points
•Always be sure that colors match when wires are connected, that wires are installed in harness tube or
supported by insulating tape after connection and that connectors match wire color in assembly.
•Make sure connectors fit properly to assure connection.
•Be sure to always test switch operation after installation.
Troubleshooting
If the brake light or turn light fails to come on
with the ignition switch "ON," it may be
caused by:
•Bad bulb
•Faulty switch
•Lead broken
•Fuse blown
•Battery discharged
•Faulty wire matching
•Bad flasher
If the fuel indicator fails to come on:
•Lead disconnected
•Wire broken
•Improper float operation
•Faulty fuel sensor
•Bad meter
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
Page Topic
17-2 Replacing the Horn Switch
17-2 Main Switch Inspection
17-3 Replacing the Main Switch
17-3 Brake Light Switch Inspection
17-3 Horn Inspection
17-3 Replacing the Horn Switch
17-2 Speedometer Removal and
17-4 Reinstallation
17-4 Headlight Removal and Installation 17-7
17-4 Bulb Replacement and Installation 17-7
17-4 Taillight, brake light, rear
17-4 position light or license light
17-5
If light is dim:
•Faulty magneto lighting coil
•Excessive voltage at matching wire or
switch
•Faulty rectifier regulator
If the dimmer switch does not operate
properly:
•Bad bulb
•Faulty switch
If fuel indicator pointer moves
unsteadily:
Loose lead connection
•Faulty fuel sensor
•Faulty meter
17-2
CHAPTER 17:METERS, SWITCHES AND LIGHTING SYSTEM
Page
17-5
17-5
17-5
17-6
17-6
17-6
17-6
17-7