Brake Light Switch Inspection; Horn Inspection; Speedometer Removal And - Panterra Fusion Service Manual

178
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
17. Meters, Switches and Lighting System

Brake Light Switch Inspection

1. Remove the speedometer cover.
2. Disconnect the front brake switch lead.
3. Operate the front brake lever to check the switch
for proper operation.
4. Disconnect the rear brake switch wire connector.
5. Operate the rear brake lever to check for proper
operation.
6. The above tests can be conducted with a
continuity tester or ohm meter.

Horn Inspection

1. Remove the front panel.
2. Disconnect the horn wire connector and connect
the terminal to a battery (12V).
3. The horn is good if it sounds properly.
4. Check operation of switch with ohm meter or
continuity tester.
To replace the horn switch:
5. Disconnect the horn switch wire connector.
6. Remove the mounting bolt.
7. Remove the horn.
8. Reverse the procedure for installation.
Speedometer Removal and Reinstallation
1. Remove front and rear handlebar covers (refer to 12-2).
2. Disconnect all the wiring connectors.
3. Remove the three set screws and speedometer.
4. Reverse the removal procedure for installation.
17-6
CHAPTER 17:METERS, SWITCHES AND LIGHTING SYSTEM