Panterra Fusion Service Manual page 118

NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
10. The Final Transmission Assembly
3. Attach the sub shaft and the
washer to the final transmission
gearbox. Install the resin washer to
the sub shaft; install the locating pin
and the new gasket.
4. Put on the final gearbox cover.
5. Tighten the bolts of the final
gearbox cover.
6. Assemble the clutch/driving
pulley disk (refer to 9-8).
7. After assembling, fill the gear box
with 90w gear oil (refer to 3-7).
Designated gear oil: SAE 90#
Volume of the gearbox:
Filling: 0.12L 4 ounces
Changing: 0.10L 3.5 ounces
8. Screw up the oil screw and
tighten it.
Torque: 1.0-1.4kg/m 8-10ft lbs
9. Start the engine to check if there
is oil leakage.
10. Check the oil level. Replenish it
with the designated gear oil when the
oil is not sufficient (through the oil
checking hole).
CHAPTER 10: THE FINAL TRANSMISSION ASSEMBLY
3
SUB SHAFT
RESIN
WASHER
GASKET
LOCATING PIN
10-6
FIX SCREW
GEAR OIL INLET
HOLE/CHECK HOLE
10
OIL DRAINAGE SCREW
115