Transmission Pulley; Checking The Clutch - Panterra Fusion Service Manual

106
9. Driving Belt Device & The Starting Lever
8. Remove the guide rolling pin from the
transmission pulley assembly, and then
take out the o-ring and the oil seal.

Checking the Clutch

Transmission Pulley

1. Check the wear of the clutch housing.
Measure the ID of the clutch housing.
Maximum service allowance:
Replace when it goes beyond
107.5mm (4.23 in.).
2. Check the wear of the clutch lining.
Measure the thickness of the lining.
Maximum service allowance:
Replace, when it is below 2.0mm
(.078 in.).
3. Measure the free length of the
transmission pulley spring.
Maximum service allowance:
Replace when it below 92.8mm
(3.65).
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
OIL SEAL
O-RING
TRANSMISSION
PULLEY
GUIDING PIN
1
2
3
9-11
CHAPTER 9: DRIVING BELT DEVICE & THE STARTING LEVER