Assembling The Driving Belt; The Driving Pulley-Dismounting; Taking The Driving Pulley Apart - Panterra Fusion Service Manual

102
9. Driving Belt Device & The Starting Lever

Assembling the Driving Belt

1. Turn the driving pulley clockwise to keep
the notches of the belt in expanded condition.
Then install the new driving belt.
2. Install the driving belt on the driving
pulley. Install the driving pulley, the starting
ratchet and 10mm (.39 in.) washer. Then
install and tighten the nut. Torque: 3,8kg/m
28ft lbs
Attention:
During assembly, be sure to align the
splints of the driving unit with those
on the crank shaft with the ratchet.

The Driving Pulley-Dismounting

3. Use a retaining device or spanner wrench
to hold the driving pulley.
4. Screw out the 10mm (.39 in.) nut, and
then remove the ratchet, the 10mm (.39 in.)
nut and the driving pulley.

Taking the Driving Pulley Apart

5. Remove the driving pulley and the sleeve
from the crankshaft.
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
DRIVING
BELT
3
DRIVING
PULLEY
STARTING
PATCHER
5
DRIVING
PULLEY
DRIVING PULLEY SLEEVE
9-7
CHAPTER 9: DRIVING BELT DEVICE & THE STARTING LEVER
1