The Battery - Panterra Fusion Service Manual

150
14. The Battery and the Charging System
Detaching the Battery
1. Remove the screws of the battery cover under
the floor mat.
2. Open the cover and remove the battery cable
attachment screws.
Attention:
First detach the negative (-) terminal wire,
then the (+) terminal wire. When detaching
the positive (+) terminal wire, make sure
that the tool does not contact the frame.
3. When assembling, operate in the opposite
sequence of dismounting.
Attention:
In order to prevent short circuiting, first
connect the (+) terminal wire, then the
negative (-) terminal wire
Checking the charging
condition (open circuit volt)
1. Open the battery cover and disconnect the
battery.
2. Measure the voltage across the terminals of

the battery.

Fully charged: 13.1V
Inadequately charged: 12.3V
Attention:
Use a volt meter to check the charging
condition.
Charging
1. Connection The (+) terminal pole of the
charger to the (+) terminal pole of the battery.
The negative (-) terminal pole of the charger to the
negative (-) terminal pole of the battery.
NIKOTA USA: PANTERRA SCOOTER SERVICE MANUAL
1
14-5
CHAPTER 14: THE BATTERY AND THE CHARGING SYSTEM
2b
2a