Install The Paper Sensor Or The Encoder Sensor - ENCAD NovaJet 800 Series Service Manual

Install the Paper Sensor or the Encoder Sensor

THROUGH SLOT
CARRIAGE ASSEMBLY
1. To install the Paper Sensor:
a. Turn the Carriage so that the bottom side of it is facing up.
b. Route the flex on the Paper Sensor through the slot in the
Carriage. Make sure the flex cable goes all the way through and does
not curl under the Carriage PWA.
c. Grasp the Paper Sensor between thumb and index finger and
guide the sides of the board into the grooves on each side of the
opening. See Figure 5-22.
d. Push the Paper Sensor board down into the Carriage Assembly
until it snaps firmly into place.
1
ROUTE FLEX
INSIDE THE
Figure 5-22. Paper and Encoder Sensor Installation.
NOTE
The Paper Sensor and Encoder Sensor are only installed
onto the right Carriage. All procedures in this section refer
to the right Carriage only.
NovaJet 800 Series Service Manual
GROOVES
ALIGN SIDES
OF PAPER
2
SENSOR
BOARD
BETWEEN
GROOVES
AND PUSH
STRAIGHT
DOWN
PUSH DOWN ON CLIP .
1
PUSH ENCODER IN OVER
CLIP . ENCODER MUST
SLIDE PAST THE RIDGES
AND SNAP INTO PLACE
Assembly\Disassembly 5-36